One of the best ways to utilize an unused basement is to add a toilet to it. It may seem to be a lot of hard work, but while you may need to spend quite an amount for the project, it is nonetheless a very doable task. The time needed for to complete the task would depend on the size of the toilet you desire to build, and even though it is a project that should be left to professionals, you can surely do it yourself as long as you have the right equipments and basic skills needed for the job. Proper planning is also imperative if you wish everything to be a success. To make that possible, here are the steps to guide you.


Step 1. Ideally, your new toilet should be located in a space right beneath an already existing toilet or bathroom, so you could simply access the same water lines and drains. If this not possible, try to find the space as close to the existing water lines as possible. Not only will this make your job faster, it will also help you save on the cost of materials as well. When it comes to the electrical lines, though, you would want to install a circuit dedicated to your new toilet alone.

Step 2. Add the frames to the new toilet using either lumber or metal. Next, install the plumbing and electrical system. For your safety, always use Ground Fault Circuit Interruption or GFCI devices to protect you from electrical shock. Install a cold and hot water line to the sink and the shower and a cold line to the toilet. When all the utilities needed for the room have been installed, it’s time to install the wall. It’s up to you whether you’re going to use wood or concrete for your wall.

Step 3. Now it’s time to install the toilet. When installing the toilet, see to it that you provide ample space for leg movement. Plumb the water line next and set your toilet in place. Connect the water line and tighten the fittings. Once the toilet has been completely installed, check it for any water leakage.

Step 4. Install the sink and connect it to the cold and hot water line you tapped into earlier, then check for leakage by running water down the drain. Install the shower next, connecting it to the cold and hot water line as well. Check for leakage as usual by turning the shower on.

Step 5. Once you’re done installing the toilet, sink, and shower, it is time to work on the walls and ceiling next. It’s up to you whether you want to cover the walls and the floor with tiles or not, but for better design and functionality, it would be best to do so.

Step 6. Add toilet and bath accessories such as a medicine cabinet, towel rods, etc. Once you’re done, your new toilet should be fully functional within the next 24 hours.